Owners Manual

NOTE: The serial null modem cable for the CMC is an option. You can access the CLI using the 17th blade feature on the

embedded iKVM module. Blade number 17 is a direct local connection to the CMC.

1. Choose a language from the options in the dialog box.

2. Start the LCD configuration wizard.

3. Configure the CMC network settings for your network environment.

• Network speed

• Duplex mode

• Protocol (IPv4 and/or IPv6)

• Network mode (DHCP or static)

• Static IP address, subnet mask, and gateway values (if static mode was selected)

• DNS setting, including a registered CMC name, (if DHCP mode was selected)

NOTE: The CMC external management network mode is set by default to DHCP. To use a static IP address, you must

change the setting using the LCD configuration wizard.

4. If required, configure the iDRAC network setting for DHCP mode.

NOTE: You cannot set a static IP address for the iDRAC using the LCD configuration wizard. To set the static IP

address, use the web-based interface.

5. Review the settings on the Network Summary screen:

• If the settings are correct, press the center button to close the configuration wizard and return to the Main Menu.

• If the settings are not correct, use the left-arrow key to return to the screen for that setting and make the appropriate changes.

The Network Summary screen lists the IP addresses for the CMC and the iDRAC network settings.

After you complete the LCD configuration wizard, you can access the CMC on the network using the web-based CMC interface or text-

based interfaces such as a serial console, Telnet, or SSH.

NOTE:

If you want to use static addresses rather than DHCP to access the iDRACs, you must configure them using the

CMC web-based interface or CLI.

Configuring The CMC Using A Management Station And

CLI

The LCD configuration wizard is the quickest way to initially configure the CMC network settings. However, you can also use a

management station and a local connection to access the CMC.

There are two ways to create a local connection to the CMC:

• The CMC Console, using the optional iKVM. Press <Prnt Scrn> and select blade number 17.

• Serial connection, using an optional null modem cable (115200 bps, 8 data bits, no parity, 1 stop bit, and no flow control).

Once you have established a connection to the CMC, you can complete the initial CMC network configuration.

1. Log in to the CMC.

The default user name is root and the default password is calvin.

2. Type getniccfg and press <Enter> to view the current CMC network parameters.

3. Configure the CMC network settings:

• To set a static IP address, type

setniccfg -s <IP address><network mask><gateway>

and press <Enter>.

• To configure the CMC to obtain an IP address using DHCP, type

setniccfg -d

and press <Enter>.

The new network settings are activated in a few seconds after configuring the network.

Initial system configuration