Owners Manual

Figure 33. 4 Gbps Fibre Channel Pass-Through Module

SFP fibre channel connectors (16) 2. fibre channel green/amber indicators (two per port)

3. power indicator 4. status/identification indicator

The following are the fibre channel pass-through indicators:

1. Power Indicator:

• Off: Power to the module is off

• Green: Module has power

1. Status/Identification Indicator

• Blue off: Secondary module in a stack

• Blue on: Primary module in a stack, if applicable

• Amber flashing: Fault condition in module

1. Fibre Channel Port Indicators With Emulex Mezzanine Card Installed

• Green off, amber off: Mezzanine board failure before POST

• Green off, amber on or green off, amber blinking: Mezzanine board failure during POST

• Green off, amber flashing irregularly: POST in progress

• Green on, amber off or green on, amber on: Mezzanine board failure during operation

• Green on, one fast amber blink: 1 Gb link established

• Green on, two fast amber blinks: 2 Gb link established

• Green on, three fast amber blinks: 4 Gb link established

• Slow green blinking, amber off: No link established

• Slow green blinking, slow amber blinking: Offline for firmware download

1. Fibre Channel Port LEDs with Qlogic Mezzanine Card Installed

2. Green off, amber off: Power off

3. Green off, amber on: Online, 1 Gb or 2 Gb link

4. Green on, amber off: Online, 4 Gb link

5. Green off, amber flashing: I/O activity, 1 Gb or 2 Gb

6. Green flashing, amber off: I/O activity, 4 Gb

7. Green flashing and amber flashing at same time: Loss of synchronization

8. Green flashing and amber flashing at different intervals: Firmware error

Configuring The I/O Modules