Owners Manual

Figure 47. Removing and Installing a CMC Module or iKVM Module (CMC Module Shown)

a. I/O connector cover

b. release latch

c. release lever

Installing An iKVM Module

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Remove the I/O connector cover.

2. Open the iKVM module handle.

3. Slide the module into the enclosure until the handle contacts the enclosure.

4. To fully seat the module, close the handle until the release latch snaps into place.

5. If applicable, connect the keyboard, monitor, and mouse to the module.

I/O Modules

CAUTION:

If you remove an I/O module, you must either replace it with another I/O module or with a filler blank to

maintain cooling airflow through the system enclosure.

Removing An I/O Module

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. If you have not already installed the cable enumerators to make removal and replacement of the I/O modules easier and faster, install

them now.

For more information, see the Rack Installation Guide at support.dell.com/manuals.

2. Disconnect the cables attached to the I/O module.

3. Lift the latch on the end of the module’s handle and rotate the handle away from the module.

Installing Enclosure Components