Owners Manual

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Press the power switch on the enclosure to turn off the system.

2. Rotate the LCD module so that the underside of the module faces upward.

3. Remove the cable cover and disconnect the ribbon cable from the LCD module.

4. Remove the Torx T8 and Torx T20 screws that secure the bezel to the enclosure.

Figure 49. Removing and Installing the Bezel

bezel 2. enclosure

3. Torx T20 screws (6) 4. Torx T8 screws (2)

Installing The Enclosure Bezel

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Attach the bezel to the enclosure using the Torx T8 and Torx T20 screws.

2. Connect the ribbon cable to the LCD module, and reinstall the cover plate.

Enclosure Midplane

Removing The Front Module Cage Assembly And Midplane

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that came with the product.

NOTE: A Torx T20 driver is required for this procedure.

1. Press the enclosure power switch to turn off the system.

Installing Enclosure Components