Owners Manual

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that came with the product.

1. Press the system power switch to turn off the system.

2. Remove the blades.

3. Remove the bezel.

4. Remove the two screws securing the control panel to the enclosure.

5. Press the catch at each end of the control-panel cable connector, and remove the control-panel cable from the underside of the

control panel.

6. Use the pull-tab to disconnect the LCD panel cable from the underside of the control panel.

Figure 52. Removing and Installing the Control Panel

control panel 2. control-panel cable

3. screws (2) 4. LCD panel cable

Installing The Control Panel

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that came with the product.

1. Connect the LCD panel cable to the new control panel.

2. Connect the control panel cable to the underside of the new control panel.

3. Reinstall the control panel using the two screws.

4. Reinstall the bezel.

5. Install the blades.

LCD Module

Installing Enclosure Components