Deployment Guide

16 Dell Networking FC Flex IOM: Deployment of FCoE with Dell FC Flex IOM, Brocade FC switches,
and Dell Compellent Storage Array
Deployment/Configuration Guide
4. Use the Broadcom Advanced Control Suite 4 to enable FCoE by selecting the single partition under
each port and clicking the Configurations tab on the right. Click the + symbol next to Resource
Reservations and click the Configure button. Check the checkbox next to FCoE (Figure 9).
5. Click Next and then Apply. Repeat this step to enable FCoE on the second port.
Figure 9 Enabling FCoE on Broadcom 57810 CAN
Note: As the FCoE adapter is being enabled, a message indicating the device driver was successfully installed may
be displayed (Figure 10). Once complete, an virtual FCoE port will be displayed under each physical port (Figure
11).