Users Guide

2-762

Cisco Catalyst Blade Switch 3120 for HP Command Reference

OL-12248-03

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

switch

Use the switch privileged EXEC on a stack member to disable or enable the specified stack port on the

member.

switch stack-member-number stack port port-number {disable | enable}

Note This command is supported only on stacking-capable switches.

Syntax Description

Defaults The stack port is enabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines

Note Be careful when using the switch stack-member-number stack port port-number disable command.

When you disable the stack port, the stack operates at half or full bandwidth .

A stack is in the full-ring state when all members are connected through the stack ports and are in the

ready state.

The stack is in the partial-ring state when

• All members are connected through their stack ports, but some are not in the ready state.

• Some members are not connected through the stack ports.

If you enter the switch stack-member-number stack port port-number disable privileged EXEC

command and

• The stack is in the full-ring state, you can disable only one stack port. This message appears:

Enabling/disabling a stack port may cause undesired stack changes. Continue?[confirm]

• The stack is in the partial-ring state, you cannot disable the port. This message appears:

Disabling stack port not allowed with current stack configuration.

stack-member-number Specify the current stack member number. The range is 1 to 9.

stack port port-number Specify the stack port on the member. The range is 1 to 2.

disable Disable the specfied port.

enable Enable the specified port.

Release Modification

12.2(50)SE This command was introduced.