Users Guide

B-36
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform dot1x
debug platform dot1x
Use the debug platform dot1x privileged EXEC command to enable debugging of IEEE 802.1x events.
On stacking-capable switches, this command enables debugging of stack-related IEEE
802.1x events.
Use the no form of this command to disable debugging.
debug platform dot1x {initialization | interface-configuration | rpc}
no debug platform dot1x {initialization | interface-configuration | rpc}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
initialization Display IEEE 802.1x-authentication initialization sequence debug
messages.
interface-configuration Display IEEE 802.1x interface configuration-related debug messages.
rpc Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.