Users Guide

2-66
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
cisp enable
cisp enable
Use the cisp enable global configuration command to enable Client Information Signalling Protocol
(CISP) on a switch so that it acts as an authenticator to a supplicant switch.
cisp enable
no cisp enable
Syntax Description
Defaults There is no default setting.
Command Modes Global configuration
Command History
Usage Guidelines The link between the authenticator and supplicant switch is a trunk. When you enable VTP on both
switches, the VTP domain name must be the same, and the VTP mode must be server.
When you configure VTP mode, to avoid the MD5 checksum mismatch error, verify that:
• VLANs are not configured on two different.switches, which can be caused by two VTP servers in
the same domain.
• Both switches have the different configuration revision numbers.
Examples This example shows how to enable CISP:
switch(config)# cisp enable
Related Commands
cisp enable Enable CISP.
Release Modification
12.2(50)SE This command was introduced.
Command Description
dot1x credentials (global
configuration) profile
Configures a profile on a supplicant switch.
show cisp Displays CISP information for a specified interface.