Users Guide

Dell 10Gb Ethernet Pass Through II Rev 1.00
13
3.3 CLI Command Reference Conventions
This section describes the 10GbE PTM CLI commands.
For each command, the following information is provided:
• Synopsis:
Lists the command name and any required or optional parameters. Variable parameters (like port
numbers) are shown in italics. Optional parameters are shown in square brackets, e.g.
[optional_parameter]. Required parameters are shown with no brackets.
• Description:
Provides a detailed description of the command and of all its parameters
•Example:
Usage example and command output.
For purpose of automation, the symbol ‘#’ is used to indicate a comment that extends until the
next new-line character.
3.4 General Commands
3.4.1 help
Synopsis:
help
Description:
Show the list of all available commands.
ADMIN: when in ADMIN mode, this command will also show commands that require
ADMIN privilege level.
Example:
# help
show port module Shows uplink module parameters
Section 3.7.2, “show port module,” on
page 17
Debug Commands
cr_read To read a 32 bit register from device number
device_num.
Section 3.8.1, “cr_read (ADMIN),” on
page 17
cr_write To write a data DWORD to address
0xHex_address to device number
device_num.
Section 3.8.2, “cr_write (ADMIN),” on
page 18
Table 5 - List of Commands
Command name Short Description Reference