Command Reference Guide

804 Fabric OS Command Reference
53-1001764-02
portThConfig
2
For more information on port threshold configuration procedures, including default values for
specific area high/low thresholds, refer to the Fabric Watch Administrator’s Guide.
Execution of this command requires a Fabric Watch License.
Operands This command has the following operands:
port_type Specifies the port type for which to configure or display Fabric Watch settings.
This operand is optional with the --show option. With all configuration
options it is required. Valid port types include one of the following:
e-port Configures or displays all E_Ports (not supported in Access Gateway mode).
fop-port Configures or displays all optical F_Ports.
fcu-port Configures or displays all copper F_Ports. This operand is supported only on
embedded platforms and only on copper ports.
port Configures or displays all physical ports.
ve-port Configures or displays all VE_Ports. Only a subset of areas can be configured
for this port type (not supported in Access Gateway mode).
-area area Specifies the area monitored by the Fabric Watch daemon. This operand is
optional with the --show option. With all configuration options it is required
The following areas are valid when configuring or displaying configuration
settings on E_Ports, optical F_Ports, copper F_Ports, and physical ports. Area
values are not case-sensitive.
CRC Cyclic redundancy check error
ITW Invalid transmission word
C3TX_TO Class 3 transmit frames discarded due to timeout.
LOS Loss of synchronization
LF Link failure
RX Receive error
TX Transmit error
PE Protocol error
LR Link reset
ST State change
TU Trunk Utilization
Only the following areas are valid for VE_Ports.
UTIL Port utilization
PKTLOSS Packet loss
ST State change