Configuration manual

Index
IN-47
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
STP (continued)
interface states
blocking 18-6
disabled 18-7
forwarding 18-6, 18-7
learning 18-7
listening 18-7
overview 18-5
interoperability and compatibility among
modes
18-11
keepalive messages 18-2
Layer 2 protocol tunneling 17-8
limitations with IEEE 802.1Q trunks 18-11
load sharing
overview 13-24
using path costs 13-27
using port priorities 13-25
loop guard
described 20-11
enabling 20-18
modes supported 18-10
multicast addresses, effect of 18-9
optional features supported 1-8
overview 18-2
path costs 13-27
Port Fast
described 20-2
enabling 20-12
port priorities 13-26
preventing root switch selection 20-10
protocols supported 18-10
redundant connectivity 18-8
root guard
described 20-10
enabling 20-18
root port, defined 18-3
root port selection on a switch stack 18-3
STP (continued)
root switch
configuring 18-16
effects of extended system ID 18-4, 18-16
election 18-3
unexpected behavior 18-16
shutdown Port Fast-enabled port 20-2
stack changes, effects of 18-12
status, displaying 18-24
superior BPDU 18-3
timers, described 18-22
UplinkFast
described 20-3
enabling 20-15
VLAN-bridge 18-11
stratum, NTP 7-2
stub areas, OSPF 38-31
stub routing, EIGRP 38-43
subdomains, private VLAN 16-1
subnet mask 38-7
subnet zero 38-8
success response, VMPS 13-29
summer time 7-13
SunNet Manager 1-5
supernet 38-8
supported port-based authentication methods 10-8
SVI autostate exclude
configuring 11-25
defined 11-6
SVI link state 11-6
SVIs
and IP unicast routing 38-5
and router ACLs 34-4
connecting VLANs 11-7
defined 11-5
routing between VLANs 13-2
switch 39-2
switch console port 1-6