Configuration manual

Index
IN-48
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Switch Database Management
See SDM
switched packets, ACLs on 34-37
Switched Port Analyzer
See SPAN
switched ports 11-2
switchport backup interface 21-4, 21-5
switchport block multicast command 26-8
switchport block unicast command 26-8
switchport command 11-17
switchport mode dot1q-tunnel command 17-6
switchport protected command 26-7
switch priority
MSTP 19-21
STP 18-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP 38-49
syslog
See system message logging
system capabilities TLV 28-2
system clock
configuring
daylight saving time 7-13
manually 7-11
summer time 7-13
time zones 7-12
displaying the time and date 7-12
overview 7-1
See also NTP
system description TLV 28-2
system message logging
default configuration 32-4
defining error message severity levels 32-9
disabling 32-4
displaying the configuration 32-14
enabling 32-5
facility keywords, described 32-14
system message logging (continued)
level keywords, described 32-10
limiting messages 32-10
message format 32-2
overview 32-1
sequence numbers, enabling and disabling 32-8
setting the display destination device 32-5
stack changes, effects of 32-2
synchronizing log messages 32-6
syslog facility 1-14
time stamps, enabling and disabling 32-8
UNIX syslog servers
configuring the daemon 32-13
configuring the logging facility 32-13
facilities supported 32-14
system MTU
and IS-IS LSPs 38-71
system MTU and IEEE 802.1Q tunneling 17-5
system name
default configuration 7-15
default setting 7-15
manual configuration 7-15
See also DNS
system name TLV 28-2
system prompt, default setting 7-14, 7-15
system resources, optimizing 9-1
system routing
IS-IS 38-66
ISO IGRP 38-66
T
TACACS+
accounting, defined 8-11
authentication, defined 8-11
authorization, defined 8-11