Owners Manual

3. Remove the hard drive or SSD cage.
Steps
1. Align the screw holes on the hard drive or SSD cage with the screw holes on the chassis.
2. Lower the hard drive or SSD cage into the chassis until it is seated firmly in place.
3. Install the four screws to secure the hard drive or SSD cage to the chassis.
Figure 53. Installing a hard drive or SSD cage
1.
standoff (4) 2. hard drive or SSD cage
3. screw (2) 4. screw hole (2)
Next steps
1. Install the hard drive or SSD backplane.
2. Install the hard drive or SSDs.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 52
Related tasks
Removing the hard drive or SSD cage on page 103
Installing the hard drive or SSD backplane on page 107
After working inside your system on page 53
Installing a hard drive or SSD on page 95
Installing and removing blade components
105