Owners Manual

2. Remove the blade from the enclosure.
3. Install the I/O connector cover.
4. Remove the system cover.
Related references
Safety instructions on page 52
Related tasks
Removing the system cover on page 56
After working inside your system
Prerequisites
Follow the safety guidelines listed in safety instructions section.
Steps
1. Install the system cover.
2. Install the blade in the enclosure.
3. Turn on the blade.
Related references
Safety instructions on page 52
Related tasks
Installing the system cover on page 57
Recommended tools
You may need the following items to perform the procedures in this section:
● Phillips #1 and #2 screwdrivers
● T8 and T10 Torx drivers
● Wrist grounding strap
● Hex nut driver-5 mm
Removing and installing a blade
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: These procedures are applicable only for full-height and half-height blades. For information about removing and
installing quarter-height blades from a sleeve, see the blade's Owner's Manual at Dell.com/poweredgemanuals.
Removing the blade
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
Installing and removing blade components 53