Manualshelf

Owners Manual

ManualsBrandsDell ManualsComputer AccessoriesPOWEREDGE M1000E
51525354555657585960
Related references
Safety instructions on page 52
Related tasks
Removing the blade on page 53
System cover
The system cover protects the innyards of the server, while also help maintaining proper flow of air inside the server. The
removal of the system cover also actuate the intrusion switch and this aids in maintaining system security.
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in safety instructions section.
2. Turn off the blade by using CMC.
3. Remove the blade from the enclosure.
4. Install the I/O connector cover.
Steps
1. Press the release button and slide the cover toward the back of the blade.
2. Lift the cover away from the blade.
Figure 9. Removing the system cover
1.
alignment guides on the system cover and the chassis 2. system cover
3. release button 4. I/O connector cover
Related references
Safety instructions on page 52
Related tasks
Installing the system cover on page 57
56
Installing and removing blade components