Owners Manual

Figure 18. Installing the memory module
a. memory module
b. memory module socket
c. memory module ejector (2)
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. (Optional) Press F2 to enter the System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the newly installed memory.
NOTE:
If the value is incorrect, one or more of the memory modules may not be installed properly. Check to ensure that
the memory modules are firmly seated in their sockets.
3. Run the system memory test in the system diagnostics.
Related references
Safety instructions on page 52
Related tasks
Before working inside your system on page 52
After working inside your system on page 53
I/O module mezzanine cards
The blade supports a variety of optional mezzanine cards. If installed, the mezzanine card(s) must be used in conjunction with a
matching I/O module(s).
For more information about I/O modules, see "Guidelines for Installing I/O Modules" in the M1000e Enclosure Owner's Manual
at Dell.com/poweredgemanuals.
Mezzanine card installation guidelines
The blade supports two mezzanine cards:
● Mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules installed in I/O module bays
C1 and C2.
● Mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules installed in I/O module bays
B1 and B2.
Installing and removing blade components
69