Owners Manual

Figure 24. Installing the USB memory key
a. USB memory key
b. USB memory key connector
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Enter the System Setup and ensure that the USB key is detected by the system.
Related references
Safety instructions on page 52
Related tasks
Before working inside your system on page 52
After working inside your system on page 53
Removing the optional IDSDM card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in After working inside your system.
4. If installed, remove the internal USB key.
5. If installed, remove the SD card(s).
Steps
1. Remove the two screws securing the IDSDM card to the system board.
2. Remove the SD card slot bracket.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
3. Lift the card up and away from the system.
Installing and removing blade components
75