Owners Manual

2. Keep the Phillips #2 screwdriver ready.
3. Remove the SD card.
4. Remove the IDSDM card.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
Steps
1. Align the following:
●
The slot on the card edge with the projection tabs on the mezzanine card support.
● The two screw holes on the IDSDM card with the standoffs on the system board.
● The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Figure 26. Installing the optional IDSDM card
1.
IDSDM card 2. screw (2)
3. SD card slot bracket 4. mezzanine card support bracket
5. IDSDM card connector on the system board 6. standoff (2)
Next steps
1. If applicable, install the SD card(s) and the internal USB key.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 52
Related tasks
Before working inside your system on page 52
Removing the optional IDSDM card on page 75
Replacing the internal USB key on page 74
After working inside your system on page 53
Installing and removing blade components
77