Owners Manual

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the mezzanine card.
Steps
1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
Figure 31. Removing the NDC
1.
slot on the NDC 2. screw (2)
3. NDC 4. standoff (2)
5. connector 6. tab projections
Next steps
1. Install the NDC.
2. Install the mezzanine card.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 52
Installing and removing blade components
83