Owners Manual

Related tasks

Before working inside your system on page 52

Removing the mezzanine card on page 70

Installing the Network Daughter Card on page 84

Installing the mezzanine card on page 71

After working inside your system on page 53

Installing the Network Daughter Card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove the NDC to replace a faulty NDC card or service other components inside the system.

CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.

1. Follow the safety guidelines listed in safety instructions section.

2. Keep the Phillips #2 screwdriver ready.

3. Remove the mezzanine card.

4. Remove the NDC.

Steps

1. Align the following:

a. The slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.

b. Screw holes on the card with the standoffs on the system board.

2. Lower the card into place until the card connector fits into the corresponding connector on the system board.

3. Secure the card with the two screws.

Installing and removing blade components