Owners Manual

Figure 35. Installing and removing a processor
1.
socket-release lever 1 2. pin–1 corner of the processor
3. processor 4. slot (4)
5. processor shield 6. socket-release lever 2
7. processor socket 8. tab (4)
Example
Enter an example that illustrates the current task (optional).
Next steps
1. Replace the processor(s).
2. Install the heat sink.
3. Reinstall the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 52
Related tasks
Before working inside your system on page 52
Installing the cooling shroud on page 59
Removing a heat sink on page 86
Installing a processor on page 90
Installing a heat sink on page 91
Removing the cooling shroud on page 58
After working inside your system on page 53
Installing and removing blade components
89