User's Manual

Rev 1.00
7
1.5 10GbE PTM Status Lights
The 10GbE PTM Status lights indicate whether the switch is receiving power from the chassis, and the state
of the 10GbE PTM.
Figure 3: Indicator LEDs
Table 4 - 10GbE PTM states and LED configurations:
Link up on off Both the internal and external links are up
Data activity on blink Link is up and data packets are sent or received
Link protocol mismatch off on
Refer to
Section 1.3, “Link Protocol Mis-
match Condition,” on page 5 for details.
LED
10GbE PTM Status
Indication Green Status
OFF OFF OFF
ON OFF Boot in Progress
10GbE PTM not ready
ON BLINKING BLUE The CMC is identifying
the
newly installed 10GbE PTM
ON ON BLUE 10GbE PTM is on and operating Nor-
mally
ON ON or BLINKING
AM
BER
Fault in System
Self-diagnosed
OFF ON or BLINKING
AMBER
Fault in System
CMC-detected
Table 3 - LED Behavior
Condition Green LED Amber LED Description
The I/O Module is on and
ready when both the blue
and green LEDs are lit.
This LED can be blue or
amber. A fault is indicated
when the amber LED is
blinking. See Table 4.