Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Error Code Message Information
LCD Message Fatal IO error on bus <
bus
> device <
device
> function <
func
>.
Details System performance may be degraded, or system may fail to operate.
Action Cycle input power, update component drivers, remove and reinstall the device.
PCI2002
Message A fatal IO error detected on a component at slot <
number
>.
LCD Message Fatal IO error on slot <
number
>.
Details System performance may be degraded, or system may fail to operate.
Action Cycle input power, update component drivers, remove and reinstall the device.
PCI3000
Message Device option ROM on embedded NIC failed to support Link Tuning or FlexAddress.
Details Either the BIOS, BMC/iDRAC, or LOM firmware is out of date and does not support
FlexAddress.
Action Update BIOS, BMC/iDRAC, and LOM firmware. If the issue persists, see Getting Help.
PCI3002
Message Failed to program virtual MAC address on a component at bus
<
bus
>device<
device
>function <
func
>.
Details Either the BIOS, BMC/iDRAC, LOM, or NIC firmware is out of date and does not support
FlexAddress.
Action Update BIOS, BMC/iDRAC, LOM, and mezzanine card firmware. If the issue persists, see
Getting Help.
PCI3004
Message Device option ROM on mezzanine card <
number
> failed to support Link Tuning or
FlexAddress.
Details Either the BIOS, BMC/iDRAC, or mezzanine card firmware is out of date and does not
support FlexAddress.
Action Update BIOS, BMC/iDRAC, and mezzanine card firmware. If the issue persists, see Getting
Help.
PCI3006
Message Failed to get Link Tuning or FlexAddress data from iDRAC.
Details Either the BIOS or BMC/iDRAC firmware is out of date and does not support FlexAddress.
Action Update BIOS, and BMC/iDRAC firmware. If the issue persists, see Getting Help.
PCI3008
Message A non-fatal PCIe error detected on a component at bus <
bus
>device<
device
>function
<
func
>.
Details System performance may be degraded.
Action Cycle input power, update component drivers, remove and reinstall the device at the next
service window.
100