Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Error Code Message Information
LCD Message System power exceeds capacity. Performance degraded. Check PSU configuration.
Details The system is currently operating in a performance degraded state to attempt protect
from a power shutdown.
Action Review system configuration, upgrade power supplies or reduce system power
consumption.
PWR1008
Message The system performance degraded because power draw exceeds the power threshold.
LCD Message System power exceeds threshold. Performance degraded. Check PSU configuration.
Details The power threshold is configured by the user or automatically by software based on
system configuration.
Action Review system configuration, upgrade power supplies or reduce system power
consumption.
RFM1003
Message Removable Flash Media <
name
> is not IPMI-function ready.
Details The removable flash media is installed but improperly configured or failed to initialize.
Action If unintended, reinstall the flash media and module.
RFM1005
Message Removable Flash Media <
name
> is not ready.
Details The media is being prepared or is under maintenance. If the problem persists, reinstall the
card.
Action Wait for the media to be ready.
RFM1006
Message Removable Flash Media <
name
> is offline.
Details At boot, the Card Identification (CID) signature of the card is different from the Non-volatile
(NV) storage value or the card is the destination of a copy operation that is in-progress.
Action If unintended, reinstall the flash media.
RFM1008
Message Failure detected on Removable Flash Media <
name
>.
LCD Message Removable Flash Media <
name
> failed. Check SD Card.
Details An error was reported during a SD card read or write.
Action Reseat the flash media, if the issue persists replace the media.
RFM1014
Message Removable Flash Media <
name
> is write protected.
LCD Message Removable Flash Media <
name
> is write protected. Check SD Card.
Details The card is write-protected by the physical latch on the SD card. A write-protected
card cannot be used.
Action If unintended, remove the media and disable write protection.
109