Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Error Code Message Information
RFM1016
Message Media not present for Removable Flash Media <
name
>.
Details The SD card is not detected or not installed.
Action If unintended, reinstall the flash media.
RFM1021
Message Removable Flash Media is not IPMI-function ready.
Details The removable flash media is installed but improperly configured or failed to initialize.
Action If unintended, reinstall the flash media.
RFM1022
Message Removable Flash Media is ready.
Action If unintended, reinstall the flash media.
RFM1023
Message Removable Flash Media is not ready.
Details The media is being prepared or is under maintenance. If the problem persists, reinstall the
card.
Action If unintended, reinstall the flash media.
RFM1024
Message Removable Flash Media is offline.
Details At boot, the Card Identification (CID) signature of the card is different from the Non-volatile
(NV) storage value or the card is the destination of a copy operation that is in-progress.
Action If unintended, reinstall the flash media.
RFM1026
Message Failure detected on Removable Flash Media.
Details An error is reported during a SD card read or write.
Action Reinstall the flash media, if the issue persists replace the media.
RFM1032
Message Removable Flash Media is write protected.
Details The card is write-protected by the physical latch on the SD card. IDSDM cannot use a
write-protected card.
Action If unintended, remove the media and disable write protection.
RFM1034
Message Media not present for Removable Flash Media.
Details The SD card is not detected or not installed.
Action If unintended, reinstall the flash media.
RFM1201
Message Internal Dual SD Module redundancy is lost.
LCD Message Internal Dual SD Module redundancy is lost. Check SD Card.
Details Either one of the SD card or both the SD cards are not functioning properly.
110