Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Error Code Message Information
Details System hardware detected an over voltage or under voltage condition.
If multiple voltage exceptions occur consecutively the system may power down in fail-safe
mode.
Action
1. Review system logs for power supply exceptions.
2. Re-seat the mezzanine card.
3. If the issue persists, see Getting Help.
VLT0232
Message The mezzanine card <
number
> <
name
> voltage is greater than the upper warning threshold.
Details System hardware detected an over voltage or under voltage condition.
If multiple voltage exceptions occur consecutively the system may power down in fail-safe
mode.
Action
1. Review system logs for power supply exceptions.
2. Re-seat the mezzanine card.
3. If the issue persists, see Getting Help.
VLT0233
Message The mezzanine card <
number
> <
name
> voltage is greater than the upper critical threshold.
Details System hardware detected an over voltage or under voltage condition.
If multiple voltage exceptions occur consecutively the system may power down in fail-safe
mode.
Action
1. Review system logs for power supply exceptions.
2. Re-seat the mezzanine card.
3. If the issue persists, see Getting Help.
VLT0234
Message The mezzanine card <
number
> <
name
> voltage is outside of range.
Details System hardware detected an over voltage or under voltage condition.
If multiple voltage exceptions occur consecutively the system may power down in fail-safe
mode.
Action
1. Review system logs for power supply exceptions.
2. Re-seat the mezzanine card.
3. If the issue persists, see Getting Help.
Warning Messages
A warning message alerts you to a possible problem and prompts you to respond before the system continues a task.
For example, before you format a hard drive, a message warns you that you may lose all data on the hard drive. Warning
messages usually interrupt the task and require you to respond by typing y (yes) or n (no).
130