Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Environmental
For temperatures between 40 °C and 45 °C, de-rate
maximum allowable dry bulb temperature by 1 °C per 125
m above 950 m (1 °F per 228 ft).
Expanded operating temperature restrictions
• Do not perform a cold startup below 5 °C.
• Maximum 95 W processor is supported.
• The following do not support the expanded
operating temperature range:
– PCIe SSDs
– LRDIMMs
– Non Dell-qualified peripheral cards
and/or peripheral cards greater than 25
W
– Dell PowerEdge RAID Controller (PERC)
H710/H710P cards (in dual-processor
configurations)
• When populating the blade slots in the M1000e
enclosure with only PowerEdge M620 blades:
– Install only 97 mm wide heat sink(s).
– Dual-processor blades with PERC H310
cards cannot be mixed with single-
processor blades.
– If you install a blade with two processors
and a PERC H310 card in the M1000e
enclosure, all blade slots in the
enclosure must have PowerEdge M620
blades with the same configuration
(PowerEdge M620 blades with two
processors and a PERC H310 card).
However, vacant blade slots in the
enclosure can be installed with blade
blanks.
71