Computer Hardware User Manual
Table Of Contents
- Contents
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- System Memory
- I/O Module Mezzanine Cards
- Management Riser Card
- SD vFlash Card
- Network Daughter Card/LOM Riser Card
- Processors
- Hard Drives/SSDs
- Hard-Drive/SSD Backplane
- System Board
- NVRAM Backup Battery
- Storage Controller Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Error Code Message Information
4. If the issue persists, see Getting Help.
AMP0306
Message Disk drive bay <
name
> current is less than the lower warning threshold.
Details Disk drive bay <
name
> current is outside of the optimum range.
Action
1. Review system power policy.
2. Check system logs for power related failures.
3. Review system configuration changes.
4. If the issue persists, see Getting Help.
AMP0307
Message Disk drive bay <
name
> current is less than the lower critical threshold.
LCD Message Disk drive bay <
name
> current is outside of range.
Details Disk drive bay <
name
> current is outside of the optimum range.
Action
1. Review system power policy.
2. Check system logs for power related failures.
3. Review system configuration changes.
4. If the issue persists, see Getting Help.
AMP0308
Message Disk drive bay <
name
> current is greater than the upper warning threshold.
Details Disk drive bay <
name
> current is outside of the optimum range.
Action
1. Review system power policy.
2. Check system logs for power related failures.
3. Review system configuration changes.
4. If the issue persists, see Getting Help.
AMP0309
Message Disk drive bay <
name
> current is greater than the upper critical threshold.
LCD Message Disk drive bay <
name
> current is outside of range.
Details Disk drive bay <
name
> current is outside of the optimum range.
Action
1. Review system power policy.
2. Check system logs for power related failures.
3. Review system configuration changes.
4. If the issue persists, see Getting Help.
AMP0310
Message Disk drive bay <
name
> current is outside of range.
LCD Message Disk drive bay <
name
> current is outside of range.
75