Users Guide

Deploying the BOSS-S1 card

This section provides a set of high-level installation and removal instructions for the BOSS-S1 card.

Topics:

• Removing the BOSS-S1 card

• Installing the BOSS-S1 card

Removing the BOSS-S1 card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that are shipped with your product.

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and

peripherals.

NOTE:

It is recommended that you always use a static mat and static strap while working on components in the interior

of the system.

2. Open the system.

3. Locate the BOSS-S1 card on the system board.

CAUTION: To prevent damage to the card, hold the card by its edges only.

4. If you are removing a BOSS-S1 modular card, loosen the screw that secures the card to the system board.

5. After ensuring that the PCIe bracket is unobstructed, lift the card to remove it from the connector on the system board.

Figure 3. Removing the BOSS-S1 adapter card

a. BOSS-S1 adapter card

b. card connector on the system board

14 Deploying the BOSS-S1 card