Users Guide

Figure 4. Removing the BOSS-S1 modular card

a. BOSS-S1 modular card

b. card connector on the system board

Removing the M.2 SSD module from the BOSS-S1 card

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that are shipped with your product.

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and

peripherals.

NOTE:

It is recommended that you always use a static mat and static strap while working on components in the interior

of the system.

2. Open the system.

3. Remove the BOSS-S1 card from the system. See Removing the BOSS-S1 card.

4. Remove the screw that secures the M.2 SSD module to the BOSS-S1 card.

5. Slide and remove the M.2 SSD module away from the card.

Deploying the BOSS-S1 card