Owners Manual

Figure 36. Installing the heat sink
1. retention screw (4) 2. heat sink
3. processor socket 4. retention screw slot (4)
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.
Related Links
Safety instructions
Before working inside your system
Installing a processor
Installing the cooling shroud
After working inside your system
Hard drives or SSDs
Your system supports up to four 2.5 inch SAS/SATA/PCIe SSDs or SAS /SATA hard drives and twelve 1.8-
inch SAS SSDs. The hard drives or SSDs are supplied in special hot-swappable drive carriers that fit in the
drive bays and these drives connect to the system board through the hard-drive or SSD backplane board.
NOTE: Mixing of SSD/SAS/SATA hard drives is not supported.
107