Owners Manual

2. Restart the system

3. Enter System Setup

4. Set the drive as first in the boot sequence

The USB device is displayed in the Boot Order Setup screen only if it is attached to the system before you

run the System Setup. You can also select the boot device by pressing F11 during system start-up and

selecting a boot device for the current boot sequence.

Diagnostic indicators on the front panel

Hard drive or SSD indicator patterns

The hard drive or SSD (Solid-State Drives) indicators display different patterns as drive events occur in the

system.

NOTE: The server module must have a hard drive or SSD or a hard drive blank installed in each drive

bay.

Figure 4. Hard drive or SSD indicators

1. drive activity indicator (green) 2. drive status indicator (green and amber)

NOTE: If the drive is in Advanced Host Controller Interface (AHCI) mode, the status LED (on the

right side) does not function and remains off.

Table 3. Drive status indicator codes

Drive-status indicator pattern Condition

Flashes green twice per second Identifying drive or preparing for removal.

Off Drive ready for insertion or removal.