Owners Manual

Figure 59. Installing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane

1. hard-drive or SSD backplane 2. release latch (2)

3. guide pin (5) 4. connector on the system board

(SATA_BP)

5. hard-drive or SSD backplane cable

connector

6. connector on the system board

(J_PERC)

7. PCIe SSD backplane cable connector 8. PCIe SSD backplane cable

9. hard-drive or SSD backplane cable

Next steps

1. Install the hard drives or SSDs in their original locations.

2. Follow the procedure listed in the After working inside your system section.