Owners Manual

Figure 61. Installing a 1.8-inch (x12) SAS SSD backplane

1. SSD backplane 2. release latch (2)

3. guide pin (6) 4. backplane cable (2)

5. backplane cable connector that connects

to the connector on the system board

6. connector on the system board

(SATA_BP)

7. connector on the expander card (EXP) 8. backplane cable connector that

connects to the connector on the

expander card

Next steps

1. Install the SSDs in their original locations.

2. Follow the procedure listed in the After working inside your system section.