Owners Manual

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your system section.

3. Keep the #2 Phillips screwdriver ready.

4. Remove the IDSDM card.

CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.

NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other

components inside the system.

Steps

1. Align the following:

• The slot on the card edge with the projection tabs on the PCIe mezzanine card support.

• The two screw holes on the IDSDM card with the standoffs on the system board.

• The hole on the SD card slot bracket with the screw hole on the IDSDM card.

2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.

Figure 25. Installing the IDSDM card

1. IDSDM card 2. screw (2)

3. SD card slot bracket 4. PCIe mezzanine card support bracket

5. connector 6. standoff (2)

Next steps

1. If applicable, install the SD card(s) and the internal USB key.

2. Install the PCIe mezzanine card.

3. Follow the procedure listed in the After working inside your system section.