Owners Manual

Figure 58. Removing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane
1.
hard-drive or SSD backplane 2. release latch (2)
3. guide pin (5) 4. connector on the system board (SATA_BP)
5. hard-drive or SSD backplane cable connector 6. connector on the system board (J_PERC)
7. PCIe SSD backplane cable connector 8. PCIe SSD backplane cable
9. hard-drive or SSD backplane cable
Next steps
1. Install the hard-drive or SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane on page 116
Removing a server module on page 52
Removing the system cover on page 55
After working inside your system on page 52
Installing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-
inch (x2) PCIe SSD backplane
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
116 Installing server module components