Owners Manual

Viewing System Setup
To view the System Setup screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
Related concepts
System Setup on page 23
Related References
System Setup details on page 24
System Setup details
The System Setup Main Menu screen details are explained as follows:
Option
Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see Integrated Dell Remote Access Controller User’s Guide at
Dell.com/idracmanuals.
Device Settings Enables you to configure device settings.
Related concepts
System Setup on page 23
System BIOS on page 24
Related References
iDRAC Settings utility on page 48
Device Settings on page 48
Related tasks
Viewing System Setup on page 24
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, setup password, set the RAID
mode, and enable or disable USB ports.
Related References
System BIOS Settings details on page 25
Boot Settings on page 26
24
Pre-operating system management applications