Owners Manual

NOTE: You must remove the PCIe mezzanine card support bracket to replace a faulty system board.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the PCIe mezzanine card.
Steps
1. Remove the screw that secures the PCIe mezzanine card support bracket to the system board.
2. Orient the PCIe mezzanine card support bracket upward and slide it until the tabs on the PCIe mezzanine card support bracket
disengage from the slots on the system.
3. Lift the PCIe mezzanine card support bracket away from the system.
Figure 19. Removing the PCIe mezzanine card support bracket
1.
screw 2. PCIe mezzanine card support bracket
3. tab on the bracket (2) 4. slot on the system (2)
5. system board
Next steps
1. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing the PCIe mezzanine card support bracket on page 75
After working inside your system on page 52
74
Installing server module components