Owners Manual

Installing the IDSDM card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that came with the product.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your system section.

3. Keep the #2 Phillips screwdriver ready.

4. Remove the IDSDM card.

CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.

NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the

system.

Steps

1. Align the following:

• The slot on the card edge with the projection tabs on the PCIe mezzanine card support.

• The two screw holes on the IDSDM card with the standoffs on the system board.

• The hole on the SD card slot bracket with the screw hole on the IDSDM card.

2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.

Figure 25. Installing the IDSDM card

IDSDM card 2. screw (2)

3. SD card slot bracket 4. PCIe mezzanine card support bracket

5. connector 6. standoff (2)

Next steps

1. If applicable, install the SD card(s) and the internal USB key.

Installing server module components