Users Guide
Initial conguration
Dell EMC recommends the following conguration threshold for better performance of the chassis. If the conguration exceeds the
threshold, then some features including rmware update, backup, and restore may not work as expected. This may also aect system
performance.
Component Count
Templates 320
Alert Policy 50
Identity pool 501
Network (VLAN) 214
Catalog 50
Baseline 50
To congure a chassis:
1 Click Devices > Chassis > View Details > Congure > Initial Conguration.
The Chassis Deployment Wizard is displayed.
NOTE: You can congure the chassis using an existing chassis prole.
2 In the Import Prole tab, click Import to open the Import Prole window.
Enter details of the network share, where the chassis prole is located and click Import.
3 In the Time Conguration tab, select the Congure Time Settings to congure the time zone and timestamp of the conguration.
4 Select the Use NTP check box to congure the primary, secondary, or tertiary NTP addresses and click Next.
NOTE
: It is recommended that at least three valid NTP servers, which synchronize to a single time source, are used to
ensure reliable synchronization.
If you select multiple NTP servers, OME–Modular selects the NTP server algorithmically.
The Activity and Alerts tab is displayed.
5 Congure the email, SNMP, and system log settings and click Next.
The iDRAC tab is displayed.
6 Select the Congure iDRAC Quick Deploy Settings check box to congure the password to access the iDRAC web interface and the
management IPs, and click Next.
You can select the slots to which the iDRAC Quick Deploy settings must be applied.
The Network IOM tab is displayed.
7 Select the Congure I/O Module Quick Deploy Settings check box to congure the password to access the IOM console and
management IPs, and click Next.
The Firmware tab is displayed.
8 Select the Congure all devices to use following catalog check box, select the network share type and click Catalog to open the
Add Firmware Catalog window.
9 Enter a name for the catalog, select the catalog source, and click Finish to save the changes and return to the Chassis Deployment
Wizard.
10 Click Next to view the Proxy tab and congure the proxy settings.
OME–Modular uses the proxy settings to access the Dell EMC website for the latest catalogs. You can also enable the HTTP proxy
settings and proxy authentication.
11 Click Next to view the Group Denition tab.
12 Select Create Group to congure the chassis group settings.
13 Click Next to view the Summary tab.
Logging in to OME-Modular
17