Users Guide

Viewing current conguration

Click Application Settings > Network > Current Settings.

The current network, IPv4, and IPv6 settings are displayed.

Conguring OME–Modular IP address

1 Click Application Settings > Network > Address Conguration.

2 Ensure that the Enable NIC option is selected.

3 Enable the desired IP version-IPv4 or IPv6.

NOTE: The IOM and OME–Modular must be registered in the DNS. Else, the message, "Warning: Unit le of

rsyslog.service changed on disk, 'systemctl daemon-reload' recommended.", is displayed.

NOTE: After rebooting OME–Modular, the public interface with the OME–Modular IP is available after 12 minutes

approximately.

4 Enable the DHCP option, and enter the IP address and other details.

Conguring OME–Modular web server

1 Click Application Settings > Network > Web Server Conguration.

2 Ensure that the Enable Web Server option is selected.

3 Enter the timeout value in minutes.

4 Enter the port number for the web server.

You can enter a port number in the 10-65535 range. The default port number is 443.

when the web server https port settings from the lead chassis are applied to member chassis as part of the add or join member task,

refresh the inventory for the lead chassis manually to see the correct https port for the member chassis, on the

Hardware > Device

Management Info page. Launch the member chassis from the lead chassis to see the port number.

Conguring OME–Modular date and time settings

1 Click Application Settings > Network > Time Conguration.

2 Select the Use NTP check box, if required, and enter the NTP server details.

3 Select the desired time zone.

NOTE

: Any change in the attribute settings leads to IP drop or unavailability of the OME–Modular web interface for

some time. However, the OME–Modular web interface recovers automatically.

Conguring OME–Modular proxy settings

1 Click Application Settings > Network > Proxy Conguration.

2 Select Enable HTTP Proxy Settings.

3 Enter the proxy address and the port number.

4 If the proxy requires authentication, select Enable Proxy Authentication and enter the credentials.

You can enable proxy authentication only if the Enable HTTP Proxy Settings option is selected.

5 Enter the proxy user credentials.

Logging in to OME-Modular