Users Guide
• The validity of the certicate
If you have the security setup privilege, you can perform the following tasks:
• View the SSL certicate that is deployed.
• Generate a new certicate signing request (CSR)
• Upload the server certicate, based on the CSR generated, to replace the default or currently deployed certicate.
Uploading certicates
To upload the certicate:
1 Click Application Settings > Security > Certicates.
2 Click Upload to browse and upload the certicate.
Generating certicate signing request
1 Click Application Settings > Security > Certicates.
2 At the bottom-right of the page, click Generate Certicate Signing Request.
3 Enter the required details and click Generate.
• OME–Modular does not create an SSL certicate on time change or on every boot or time change and boot simultaneously.
• OME–Modular generates a new SSL certicate with validity from build_time till (build_time +10 years) only during rst boot
scenarios such as rmware update,
racresetcfg, and FIPS mode changes.
NOTE: Only the users with the chassis administrator privileges can generate certicate signing requests.
Conguring alerts
This section allows you to congure the email, SNMP, and the syslog settings to trigger alerts.
Conguring email alerts
1 Click Application Settings > Alerts.
2 Click Email Conguration
3 Enter the SMTP Server Network Address.
NOTE
: The SMTP server network address can have a maximum length of 255 characters.
4 If the server requires authentication, select Enable Authentication.
NOTE
: If Enable Authentication is selected, you must provide the username and password to access the SMTP server.
5 Enter SMTP Port Number.
6 If the SMTP server is congured to use SSL, select the SSL option.
Conguring SNMP alerts
The SNMP alerts contain the service tag of the chassis as one of the parameters in the trap. Third-party consoles can use this information
to correlate the traps with the system.
For network IOMs and compute sleds, OME–Modular subscribes to alerts through internal private VLANs—SNMP or REST. For MXG610s
ber channel switching modules, only SNMP V1 is supported and you can congure only four SNMP alert destinations.
You can congure the SNMP alert destination for IOMs from the Application Settings > Alerts > SNMP Conguration page. After
conguring the SNMP destination, go to
I/O Settings > Replicate Alert Destinations.
Logging in to OME-Modular
37