Users Guide

– 1 Minute

– 10 Minutes

– 30 Minutes

– 1 Hour

– Indenitely

• Conguration Prole tasks:

– Associate server proles—You can associate proles to blade servers. The prole is extracted from the server and is attached to

the slot containing the server.

– Migrate server proles—You can migrate a prole from one server to another. The system unassigns the identity from the rst

server before the migration. If the unassignment fails, the system displays a critical error. You can override the error and force the

migration to a new server.

– Edit server proles—You can edit the prole characteristics that are unique to the device or slot. If a prole is attached to a

compute, the updated prole conguration is propagated to the compute.

– Remove slot associations—You can detach the server prole from the slot.

NOTE: When a compute sled is inserted into a chassis, sometimes the message, "No device image found", is displayed. To

resolve the issue refresh the inventory of the compute sled, manually.

Conguring compute settings

You can congure the following compute settings:

• Network

• Management

Conguring compute network settings

To congure the compute network settings:

1 Click Devices > Compute > View Details > Settings > Network.

2 In the General Settings section, select the LAN Enablement check box to congure the network settings.

3 Congure the IPv4, IPv6, and management VLAN settings.

Conguring compute management settings

To congure the compute management settings:

1 Click Devices > Compute > View Details > Settings > Management.

2 Congure the password to access the iDRAC console and select IPMI over LAN to enable access from OME–Modular to iDRAC,

through BIOS.

Viewing compute hardware

You can view the details of the hardware components that are installed in the compute sled, on the compute Hardware page. The

hardware components include processor, storage controller, and FRU.

NOTE: If the storage controller cards are absent in iDRAC, the storage enclsoure details are not displayed on the Compute >

View Details > Hardware > Storage Enclosure page.

Viewing compute rmware

You can view the rmware list for the compute in the compute Firmware page. Click Devices > Compute > View Details > Firmware.

Managing compute sleds