Users Guide

Conguring IOM network settings
The network settings for IOMs include conguring the public management IP for the selected management port.
To congure the networking settings:
1
Click All Devices > I/O Modules > View Details > Settings > Network or Devices > I/O Modules > View Details > Settings >
Network.
2 In the IPv4 Settings section, select Enable IPv4.
3 Enter the IP Address, Subnet Mask, and Gateway for the management port.
The IP Address, Subnet Mask, and Gateway options are enabled only if the Enable DHCP check box is cleared.
4 In the IPv6 Settings section, select Enable IPv6.
5 Enter the IPv6 Address, select the Prex Length.
The IPv6 Address, Prex Length, and Gateway options are enabled only if the Enable Autoconguration check box is cleared.
6 Enter the Gateway for the management port.
The IPv6 Address, Prex Length, and Gateway options are enabled only if the Enable Autoconguration check box is cleared.
NOTE: For tagged or untagged VLAN network, any IPv6 setting congured using OME - Modular may not have the
default gateway. To get the default gateway, go to the respective OS10 CLI and enable Stateless Address
Autoconguration (SLAAC) on the respective tagged or untagged VLAN.
7 In the DNS Server Settings section, enter the Preferred DNS Server, Alternate DNS Server 1, and Alternate DNS Server 2
addresses.
For MXG610s IOMs, you can set the Preferred DNS and Alternate Server 1 and 2 addresses. However, the server address for
Alternate DNS Server 2 is not applied though the response is successful as, MXG610s IOMs support only two server address for DNS
settings.
8 In the Management VLAN section, select Enable VLAN and enter the VLAN ID.
For MXG610s FC IOMs, DHCP works only without VLAN while Static IP works with or without VLAN conguration. To change the IP
conguration from DHCP IP to Static IP, perform the following steps:
a Disable DHCP, congure the static IP, and save the conguration.
b Enable VLAN, congure the VLAN ID, and save the conguration.
Conguring root password
To congure the root password:
1 Click All Devices > I/O Modules > View Details > Settings > Management or Devices > I/O Modules > View Details > Settings >
Management.
The I/O Modules page is displayed.
2 Enter the Host Name and Root Password for the IOM.
Conguring SNMP settings
To congure the SNMP settings:
1 Click All Devices > I/O Modules > View Details > Settings > Monitoring or Devices > I/O Modules > View Details > Settings >
Monitoring.
2 Select Enable SNMP to congure the SNMP version and community string.
Ethernet IO Modules
59