Users Guide

• Network Path
Editing catalogs
You can only modify the catalog name, network share address, and catalog lepath.
To edit catalogs:
1 On the Catalog Management page, select the catalog that you want to edit and click Edit.
The Edit Firmware Catalog window is displayed.
2 Make the required changes.
Deleting catalogs
You can only delete catalogs that are not associated with a baseline. If you attempt deleting a catalog that is associated with a baseline, an
error message is displayed.
To delete a catalog:
On the Catalog Management page, select the catalog that you want to delete and click Delete.
Updating rmware
Before updating the rmware on a chassis, compute, or storage sleds, ensure that all IOMs and network fabrics are healthy.
NOTE
: The Update Firmware button may be disabled temporarily during inventory refresh when a Refresh Inventory job or
Default Inventory job is run.
To update rmware:
1 On the Compliance Report page, select the device or component for which you want to update the rmware.
The Update Firmware window is displayed.
2 Select the Update Now option to update the rmware immediately or Schedule Later to update the rmware on the chosen date and
time.
NOTE
: If the system displays the local clock on the Time Conguration page even after you congured the NTP
servers, recongure the NTP servers.
NOTE: During rmware update, when the active MM reboots and the standby MM is active, some messages on the
Execution Details page for the rmware update are not displayed. The messages are not displayed owing to
synchronization issues.
NOTE: During the OME–Modular rmware update, multiple users can upload the OME–Modular DUP using any
interface. However, a warning message may be displayed after the rmware update job is initiated.
NOTE: For non-default VLAN, the management IPv6 IP of MX9116n or MX5108n IOMs is unreachable if, the DHCP V6
conguration in ToR switch does not have the IPV6 default gateway.
Rolling back rmware
If you are not convinced with the rmware update of a device or component, you can roll back the update to the version before the update.
The rollback option is enabled only if OME–Modular can access the rmware package of the previous version. The following methods can
be used to enable the access:
• A Device that has the rollback version (or N-1 version) that matches the previous version. Not all devices support a rollback or N-1
version. The rollback version is displayed as a rollback candidate even if it does not match the version before the update.
• An imported catalog that has a reference to the previous catalog version.
Managing
rmware 81