CLI Guide

• powerdown—perform server power off
• powerup—perform server power on
• powercycle—perform server power cycle
• hardreset—force hard server power reset
• graceshutdown—perform graceful shutdown of server
• reseat—perform a virtual reseat of a server/storage
NOTE: This action requires -f option to force the action.
•
powerstatus—display current power status of server
NOTE: This action is not allowed with -a option
Synopsis
racadm serveraction -m <module> <action>
racadm serveraction -a <action>
Input
• -m—The <module> must be server-<n>, where n = 1 to 8
• -a—Performs power action on all servers
Example
• Power action on a single server:
racadm serveraction -m server-1 powerdown
• Power action on all servers:
racadm serveraction -a powerup
• Reseat action on a single storage:
racadm serveraction -m storage-2 -f reseat
setniccfg
Description
Modifies network configuration properties.
Synopsis
racadm setniccfg [-m <module>] -d
racadm setniccfg [-m <module>] -s <ipAddress> <netmask> <gateway>
racadm setniccfg [-m <module>] -v [vlan_id]
Input
• -m—The <module> option must be one of the following values:
• switch-<n>, where n = 1-6
• chassis—The default state if -m is not specified.
• -d—Enables DHCP for the Ethernet management port.
•
-s—Enables static IP address, netmask, and gateway settings.
NOTE:
• Enter the IP address, netmask, and gateway as dotted decimal strings.
• Command also supports VLAN Configuration.
• -v—VLAN settings has the following legal values:
• If there are no arguments, it implies that the VLAN tag must be removed.
• <vlan_id> : 1-4000, 4021-4094
NOTE:
Disable the DHCP option to configure the static IP.
RACADM sub command details 23