Owners Manual

Figure 25. Installing a power supply unit

Next steps

1. Connect the power cable to the corresponding PSU connector on the rear of the chassis.

NOTE:

When installing or hot swapping a PSU, wait for 15 seconds for the system to recognize the PSU and

determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is

discovered and enabled before you remove any PSU. The PSU status indicator turns green to indicate that the PSU

is functioning properly.

Acoustic baffle

NOTE: Ensure to install the air baffle to reduce the noise level of the enclosure.

Removing the air baffle

Steps

1. Press the release latch to detach the air baffle from the enclosure.

2. Pull the air baffle to remove it from the enclosure.

Installing and removing system components