Owners Manual

Figure 56. Installing the heat sink onto the processor

Next steps

1. Install the processor and heat sink module.

2. Install the air shroud.

3. Follow the procedure listed in After working inside your sled on page 17.

Installing a processor and heat sink module

Prerequisites

CAUTION:

Never remove the heat sink from a processor unless you intend to replace the processor. The heat

sink is necessary to maintain proper thermal conditions.

1. Follow the safety guidelines listed in Safety instructions on page 16.

2. Follow the procedure listed in the Before working inside your sled.

3. If installed, remove the processor dust cover.

Steps

1. Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on

the processor socket.

CAUTION: To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.

NOTE: Ensure that the PHM is held parallel to the system board to prevent damaging the components.

2. Push the blue retention clips inward to allow the heat sink to drop into place.

3. Using the Torx #T30 screwdriver, tighten the screws on the heat sink in the order below:

a. Partially tighten the first screw (approximately three turns).

b. Tighten the second screw completely.

c. Return to the first screw and tighten it completely.

Installing and removing system components