Owners Manual

Removing the PERC card

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Follow the procedure listed in Before working inside the sled.

3. Disconnect the cable connected to the PERC card.

Steps

1. Pull the blue pull tag to raise the lever up on the PERC card.

NOTE: For the H730P MX(non-RAID) card, pull the two blue pull tags to raise the lever up. Rest of the procedure to

remove the PERC card remains identical to HBA330 MX (non-RAID) card.

NOTE: The MX740c supports both HBA330 MX or H730P MX PERC card.

2. Holding the blue pull tag, lift the PERC card away from the system.

Figure 62. Removing the PERC card (HBA330)

Next steps

1. Follow the procedure listed in After working inside your sled on page 17.

Installing the PERC card

Prerequisites

1. Follow the safety guidelines listed in Safety Instructions.

2. Follow the procedure listed in Before working inside the sled.

Steps

1. Pull the blue pull tag to raise the lever up on the PERC card.

2. Align the connector on the PERC card with the connector on the system board.

NOTE: The procedure to install the HBA330 MX or a H730P MX PERC card is the same.

NOTE: The MX740c supports both HBA330 MX or H730P MX PERC card.

3. Align the guides on the PERC card with the slots on the system.

Installing and removing system components